Collision Devices TARS Fuzz Analog Filter Pedal
by Collision Devices
$390.00
TARS’ fuzz part comes from the Black Hole Symmetry "Singularity" section. Put it through the analog "MS-20 style" filter to create fuzzy-noisy textures. Cut through the mix with the different filter and EQ possibilities or sweep between the frequencies to create huge waves of noise.
Controls:
Specs:
Controls:
- Gain : Placed after the Jfet transistor input stage and followed by silicon gain and clipping stages.
- Master : Master volume.
- CutOff : This fader controls the cutoff frequency of the MS-20 style low pass filter. Based on a LM13700 stage. Goes from 15Hz to 44kHz.
- Resonance : Increases the intensity of the signal around the cutoff frequency.
- LPF VOL : VCA - sets the output volume of the filter. Pretty useful to adjust the filter to your setup.
- 2p/4p toggle switch : Select the attenuation curve. Cut at -12dB/octave (2p) or at -24dB/octave (4p).
- Add Fuzz (On/Off) toggle switch : Add an extra unfiltered fuzz signal. The result is louder and creates cool frequencies boost or cut depending on the cutoff position.
- S / P toggle switch : Put the fuzz through the filter in serial - or use both effects in //.
- Expression/CV : The Expression/CV control is linked to the cutoff fader. The cutoff fader value sets the lowest value the EXP pedal can go.
Specs:
- Maximum current draw: 150 mA
- Imput Impedance: 1 MOhm
- Size: 120 x 90 x 55mm
- Voltage: +9V DC (negative center)
- Output Impedance: 1 KOhm
- Weight: 150gr
- The use of an isolated power supply is recommended for powering all Collision devices Pedals.
- Power supply not included.
- The pedal is true bypass
- Lifetime warranty
